Наш магазин на Amazon
Easy-to-read displayDedicated slots for optical interface, printer/remote-control moduleAdditional eight slots for other interface and measurement modulesFull width printing of screen (screen dump)View events graphically with timestampsOptical power measurements (option)Measurement of clock frequency and amount of frequency offset; test for network clock recovery capabilityTrouble Scan mode for alarm and error scanPDH/DSnAlarm Scan mode to show the state of all alarms when scanning within a PDH/DSn network hierarchy.Check 64 kb/s or Nx64 kb/s 1 to 31 contiguous and nondigital paths (to ITU-T G.704 contiguous timeslots)Access to and modification of spare bitsGenerate alarms to check PDH/DSn network elements and tributary insert portsSDHView the section and path overhead bytes of a received SDH signalOverhead sequences and overhead BER measurementRSOH or MSOH DCC drop and insertPDH drop and insert - Drop/insert of 34/140/2 Mb/s to or from an STM-1/STM-4 signalPointer adjustments and analysis, and pointer location graphThru mode for in-service monitoring where no protected monitor points are availableSDH alarm scan (in-service) and BIP scanPositive and negative pointer adjustments followed by analysisMixed payloads - Generate mixed TU-3 and TU-12 signal structures to test network elements, configured to carry mixed 2 Mb/s and 34 Mb/s trafficAutomatic verification of VC-n paths, using the out-of-service tributary scan for faster installation testingSONETOverhead access and BER measurementDrop and insert of TOH and TOH DCC channelsPointer adjustments and analysis, and pointer location graphSONET alarm scan (in-service) and BIP scanDSn/PDH drop and insertThru mode for in-service monitoring where no protected monitor points are availableAutomatic verification of VTn paths using the out-of-service tributary scan for faster installation testingMixed payloads - Generate mixed STS-1 signal structures within STS-3/OC-3 signal structures to test network elementsATMChange cell stream bandwidth to quickly obtain quality-of-service data for the ATM networkAAL monitoringGraphical display of maximum, mean, and minimum cell rate on a chosen VC for short or extended periodsPing tests for Ethernet LAN interfacesChannel viewGraphical display for 1-point and 2-point cell delay variation and non-conforming cell counJitterAutomatic jitter tolerance test for verifying network equipment performance marginsTest jitter accumulation in regenerative repeatersJitter sweep and spot frequencyPDH and SDH output jitter measurements
Нет отзывов об этом продукте
Вы можете задать нам вопрос(ы) с помощью следующей формы.
Пожалуйста, сформулируйте Ваши вопросы относительно HP/Agilent 37717C Omni Ber 717 :